companiesbta.blogg.se - Codemeter runtime server error 1053

Hello, we have another issue with CodeMeter:

In case the previous steps haven't solved the issue, contact your local GRAPHISOFT distributor with the diagnostic files described here: CodeMeter/ErrorReporting

also the CodeMeter service should run as server: CodeMeter WebAdmin/Configuration/Network - Run Network Server checkbox.

make sure the network connection works reliable.

check the firewall settings and make sure 22350 - or the used - port is open.

If it fails telnet will give an error message:

the sign of the success is a blinking cursor, which proves that the connection was possible.

In Command Prompt give the following command:.

To install it follow Micrososft's description.

By default telnet is not part of the Windows installation package.

If the connection is possible and is alive the terminal shows the following state:.

Server name can be the hostname or the IP address of the server computer, 22350 is the default port for CodeMeter communication, can be changed in CodeMeter/WebAdmin.

Open a terminal window and give the following command:.

Make sure the CodeMeter related network communication is possible. Visit and follow the steps there to activate the protection key via the downloaded GRAPHISOFT License Manager Tool (LMT). Make sure the license key has the proper license/licenses loaded to run the purchased GRAPHISOFT products.

Verify the Access Control settings - the list should be empty (all access) / the allowed peers should be specified (limited access).

Check whether the CodeMeter server runs as server - WebAdmin/Configuration/Network - Run as Network Server.

Restart all related computers, even the server.

Use the latest available driver for your operating system from the previous page. The driver itself is installed with ARCHICAD, but you can download it from: GRAPHISOFT's home page Sometimes a new driver is released for a new operating system.

Make sure all computer have the CodeMeter driver installed.

CodeMeter/LicenseBorrowing article explains how borrowing works and helps to set it up.

The general CodeMeter article describes the protection system.

Go through the CodeMeter documentation here on Help Center In this article you can find a collection about the discovered known issues: CodeMeter/KnownIssues The error code ARCHICAD gives can help you to discover the problem, also here you can find a collection about the most typical problem with solutions: CodeMeter/ErrorCodes